Amiable Impex

Starting / Ignite Powder is also known as Starting Powder and is required and is must. Sprinkle little Starting Powder on the Mould followed by the Exothermic Welding powder and again sprinkle it little on the Top Side of Mould. Than Ignite starting powder with a spark gun.

This results in exothermic reaction and the Welding powder melts to molten copper alloy. The molten copper alloy melts the retaining disc and flows into the Welding cavity where it partially melts the conductors.

For most connections involving lugs, cable or rectangular bus, exothermic handle clamps are used. These will fit 90% of all standard Mould Handle Clamp. Normally we recommend One Handle for every two moulds. These are manufactured by the professionals using high quality raw material. These Mold Handle Clamp conform their adherence with the industry standards.

Features:

• Light in weight (Nearly 1.5 to 2.0 Kg)
• Handy in nature
• Rust-proof
• Tare used for two part molds

Gloves for Exothermic Welding. Gloves iares required for safety purpose as the Exothermic Welding Powder melts at more than 1400 degree Celsius.

We recommend a Pair of Gloves for Every 150 Joints

Features:

• High quality Gloves that can easily bear heat upto 400 degree Celsius which is more than enough to Hold the Mould.

It is used to remove the metal Scrap from Mould after the Exothermic Welding / Exothermic Weld Process is done.

We recommend One Slag Tool for Every 200 Joints

It is used to clean the objects to be Exothermic Welding / Exothermic Weld

We recommend One Slag Tool for Every 100 Joints

Graphite absorbs moisture from weather. So there is a need for propane torch to dry out the inside of the Graphite Mould thoroughly on both sides, therefore heating the mold to approximately 250 degrees Fahrenheit

We recommend using one Flame torch for Every 200 Joint and than use the refiling

Steel Disk for Exothermic Welding. Steel Metal Disk Steel discs are very important. The disc acts timing device to allow the Welding powder to heat to proper temperature. Steel Disk is designed to contain the exothermic reaction to the upper crucible of a mold until the reaction is complete and ready to Welding. One Metal is must for every shot

Features:

• Depressed center
• Medium hard bond
• High speed rotation

Soft Brush and Hard Brush are used to Clean Mould Welding Cavity because its shape is very sensitive and there should not be any damage while using Brush, so

We recommend to use Soft Hard Brush are used to clean other section of Mould. We recommend a Pair of Brush for 50 Connection

It is designed with the advantages of safety and convenience. It is used to ignite Starting, Powder in order to result in exothermic Reaction.

We recommend one Flint Gun for every 100 Shots

Sun Glass is Using For Eye Safety

We Recommend Using Sun Glass For Every 100 Joint.

MASSAGE GUN Rm-806

When making a copper wire connection of Ground rod or other metal connection, place the Welding powder into the Graphite Mould. Just ignite to start the Welding process. The result will be clean and smooth connection surface. It is also applicable for other metal such as: Iron, Galvanized Steel, Railway track, Cast Iron, Bronze, and Brass. It can be used in various applications to have the certainly good connections in work. Such as Lightning and Surge Protection, Grounding in Electrical Work, Railway Construction, Cathodic Protection.

The connection mould is designed to last for an average of 60 to 100 connections. This will vary according to the care given the mould during use.Graphite mould is made of high quality graphite suitable for high quality Welding work and can be used for several times.

Features:

• Dimensional accuracy as per the customers demand.
• High quality Graphite which ensures Longer Life.